This module contains an interface to the PCSensor HidTEMPer and PCSensor HidTEMPerNTC temperature sensors. There are also the common functions for the device itself (Device) and the sensors (Sensor) laying the grounds for other HidTEMPer versions to be added later on.
The current temperature can be returned either using the Celsius scale or the Fahrenheit scale.
WARNING
The results returned from this code needs to undergo more testing. If the code used to write to the device is not used with extreme care it may destroy the device.
TODO
Please contact me if you find anything to be missing.
INSTALLATION
To install this module type the following:
perl Makefile.PL
make
make test
make install
DEPENDENCIES
This modules uses the following other modules:
use Carp
use Device::USB
use Device::USB::Device
use Time::HiRes qw / sleep /
This module uses the strict and warning pragmas.
DEVICE COMMANDS
Get information from the device:
Command: 0x52
Returns 8 bytes of interest:
1) Unknown
2) Device ID
3) Inner calibration
4) Inner calibration
5) Outer calibration
6) Outer calibration
7) unknown
8) unknown
Command: 0x61
Set gain value, the command equals the gain to be set, 0x61, 0x62....0x68
Command: 0x41
Returns 3 bytes of value
1) Primary value
2) Decimal value
3) unknown
Command: 0x43
Set configuration of the device to 0
COPYRIGHT AND LICENSE
Copyright (c) 2010-2011 Magnus Sulland
This program is free software; you can redistribute it and/or modify it under the same terms as Perl itself.